- mice-discuss - lists.micemn.net

Please welcome Apple to MICE!
by Jay Hanke Oct. 25, 2019

Oct. 25, 2019

Name: Apple Ports: Ethernet 3/14/1 (100G LAG #1), Ethernet 4/49/1 (100G LAG#2) ASN: 714 (LAG Group #1) IPv4: 206.108.255.146/24 IPv6: 2001:504:27:0:0:2ca::1/64 (LAG Group #2) IPv4: 206.108.255.147/24 IPv6: 2001:504:27:0:0:2ca::2/64 Peering Contact: peering(a)group.apple.com Route Servers: NO BFD: NO Please note: Ethernet 4/49/1 has been reclaimed from a member that failed to migrate and did not respond. Welcome aboard! -- Jay Hanke, President South Front Networks jayhanke(a)southfront.io Phone 612-204-0000

3 2

Re: Zayo to Omaha IX down
by Jeff Dahna Oct. 24, 2019

Oct. 24, 2019

288 ct fiber damaged near Worthington, MN. Zayo ticket 0646hrs - Current Update: Crews are finishing boring on one end and should have the fiber tails in the trailer in about an hour. On the other side they have fiber tails in the trailer beginning to prep.

2 1

Zayo to Omaha IX down
by Jeff Dahna Oct. 24, 2019

Oct. 24, 2019

We lost our route to Omaha IX via Zayo around 2:04 PM CST. Got a ticket in with Zayo. Anyone else down to Omaha via Zayo? Jeff Dahna Windomnet

4 4

Re: Zayo to Omaha IX down
by Justin Huffman Oct. 23, 2019

Oct. 23, 2019

Our link from Sioux City to Minneapolis went down around 2:10 today. This is getting out of hand. I think we've experienced outages every other week for almost 2 months now along with the outage lasting 16+ hours. Does anyone have recommendations for diverse routes up to 511? Justin Long Lines Broadband

1 0

Re: Problem with my connection to MICE
by Keith Anderson Oct. 22, 2019

Oct. 22, 2019

Thanks everyone. Another MICE member reached out to me directly and said they had a similar problem with this Brocade "feature" and advised me how to filter this unwanted traffic. The port now appears to be online and I can re-enable my peering tonight.

2 1

Re: Problem with my connection to MICE
by Keith Anderson Oct. 22, 2019

Oct. 22, 2019

Thanks, Jeremy. I was hoping you could provide just that sort of detail. I'm just not sure how there would be multiple coming from my side when this is a P2P link and the switch port is in route-only mode; I may have to work with Brocade on that. I will look into it, but can you tell me if the MAC addresses appear to be all from the same vendor?

2 1

Re: Problem with my connection to MICE
by Jeremy Lumby Oct. 22, 2019

Oct. 22, 2019

We are seeing Port security errors on your port for too many Mac addresses. The industry standard is one Mac address, however currently mice allows up to five. Jeremy Lumby Minnesota VoIP 9217 17th Ave S Suite 216 Bloomington MN 55425 Main 612-355-7740 Direct 612-392-6814 EFax 952-873-7425 jlumby(a)mnvoip.com -------- Original message -------- From: Keith Anderson <keith.anderson(a)MARCONET.COM> Date: 10/22/19 8:33 AM (GMT-06:00) To: MICE-DISCUSS(a)LISTS.IPHOUSE.NET Subject: [MICE-DISCUSS] Problem with my connection to MICE _____ >From : Keith Anderson [keith.anderson(a)MARCONET.COM] To : MICE-DISCUSS(a)LISTS.IPHOUSE.NET [MICE-DISCUSS(a)LISTS.IPHOUSE.NET] Date : Tuesday, October 22 2019 08:23:08 Good morning all. I have a problem with my MICE connection and I'm wondering if anyone can give me some direction. On September 9th, my predecessor disabled our port facing MICE due to BGP flapping (his description). Since there was chatter on this board about a fiber cut that day, he thought it was related to that. Unfortunately, when I re-enabled the port, I saw similar behavior. BGP seems to flap about every three minutes, and my log indicates that link is actually dropping on that port. Even though light levels never seem to drop below -4.4db, I had Cologix check the cross connect, clean the ends of the fiber, and re-seat the sfp. None of that helped. On Wednesday I replaced the SFP, but when I enabled the port, I still saw the same behavior. Last night I disabled all of my BGP peers and brought the port back online for further layer2 testing, but I can't ping any of my peers and I'm not seeing any arp entries on this port. Anyone have any ideas what could be going on or what I should check next? I've included my port config below for reference. The log entries associated with this problem are: Oct 22 08:17:33:I:SYSTEM: port 2/4 link fault status is cleared(physical link goes down 24) Oct 22 08:17:33:I:SYSTEM: port 2/4 is down( local fault) Oct 22 08:17:33:I:System: Interface ethernet 2/4, state down - local fault Oct 22 08:17:09:I:System: Interface ethernet 2/4, state up Oct 22 08:16:45:W: Latched low RX Power warning, port 2/4 Oct 22 08:16:45:A: Latched low RX Power alarm, port 2/4 interface ethernet 2/4 port-name BGP peering with MICE Arista 5/19 XC23175 load-interval 30 no fdp enable no cdp enable route-only ip address xxx.xxx.xxx.xxx/24 no spanning-tree sflow forwarding !

1 0

Problem with my connection to MICE
by Keith Anderson Oct. 22, 2019

Oct. 22, 2019

Good morning all. I have a problem with my MICE connection and I'm wondering if anyone can give me some direction. On September 9th, my predecessor disabled our port facing MICE due to BGP flapping (his description). Since there was chatter on this board about a fiber cut that day, he thought it was related to that. Unfortunately, when I re-enabled the port, I saw similar behavior. BGP seems to flap about every three minutes, and my log indicates that link is actually dropping on that port. Even though light levels never seem to drop below -4.4db, I had Cologix check the cross connect, clean the ends of the fiber, and re-seat the sfp. None of that helped. On Wednesday I replaced the SFP, but when I enabled the port, I still saw the same behavior. Last night I disabled all of my BGP peers and brought the port back online for further layer2 testing, but I can't ping any of my peers and I'm not seeing any arp entries on this port. Anyone have any ideas what could be going on or what I should check next? I've included my port config below for reference. The log entries associated with this problem are: Oct 22 08:17:33:I:SYSTEM: port 2/4 link fault status is cleared(physical link goes down 24) Oct 22 08:17:33:I:SYSTEM: port 2/4 is down( local fault) Oct 22 08:17:33:I:System: Interface ethernet 2/4, state down - local fault Oct 22 08:17:09:I:System: Interface ethernet 2/4, state up Oct 22 08:16:45:W: Latched low RX Power warning, port 2/4 Oct 22 08:16:45:A: Latched low RX Power alarm, port 2/4 interface ethernet 2/4 port-name BGP peering with MICE Arista 5/19 XC23175 load-interval 30 no fdp enable no cdp enable route-only ip address xxx.xxx.xxx.xxx/24 no spanning-tree sflow forwarding !

1 0

2019 Election Results
by AnthonyAnderberg＠nuvera.net Oct. 17, 2019

Oct. 17, 2019

Richard was re-elected unanimously, thanks for your continued service! [cid:60F64B08-B963-4E01-B287-F9A49C3DDDFD-L0-001] Sent from my iPhone

2 1

MICE UG 33
by Richard Laager Oct. 15, 2019

Oct. 15, 2019

Reminder: UG 33 is on Wednesday of this week (October 16) at 3:00pm Remote Conferencing: 952-562-5400 passcode MICE (6423) Location: 511 Building Cafeteria Agenda The agenda is attached. I'm behind on getting this out, so I didn't send a separate call for agenda. If you have something to add, let me know ASAP and I'll send an updated agenda. I'd like to try the modified ordering again. The idea here is to group business (official reports and things that could involve a motion/vote) before open discussion. This way, people who are not interested in the discussion can leave earlier if they wish, confident that they won't miss an official motion/vote. By shortening the "mandatory" part of the meeting, this may make the meetings more accessible. I'd like to give this a try for a couple meetings and see what people think. The UG 32 draft minutes are also attached. -- Richard

1 0